This tutorial teaches how to reset a Magic Home LED Strip to factory settings. It involves turning off power, mounting the controller, wiring the LED lights, connecting the controller to WiFi, linking lights and setting up groups, and customizing the settings. The Magic Home app allows users to control smart LED lights from Android/iOS devices.
Some common issues with Magic Home LED Strips include flashing different colors, disconnecting the wifi, and difficulty connecting to the app. To troubleshoot these issues, follow these steps:
- Turn off power and mount the controller.
- Wire the LED lights to the controller.
- Connect the controller to WiFi.
- Link lights and set up groups.
- Customize and customize the settings.
The Magic Home app allows users to control smart LED lights from Android/iOS devices. However, some users have reported issues with the LED strips flashing different colors after resetting the controller.
To reset the WiFi RGB or RGBW module, power on and off the bulb three times (on-off-on-off-on-off-on) (2 seconds between each turn on and off). To change ID or WiFi network, enter setup mode by powering on and off the LED strip from the homeapp button.
To check if your Smart Device is reset to factory mode, turn on the power and go to the phone’s Wi-Fi interface to find the bulb’s default settings.
Performing a factory reset on the LED lights themselves and pairing again often resolves app connectivity problems. Be prepared to re-enter the app when needed.
📹 LED WiFi CONTROLLER – MAGIC HOME – HOW TO RESET? (RGB / RGBW)
In this tutorial I will show you how to reset wifi rgb or rgbw module to factory settings.
📹 How to restore magic home bulb factory settings ?
I have the same problem, I am sure of one thing, if I keep all the bulbs off and have a new router/reset the router while it is not turned on, I am not able to pair it anymore. I need help on how to solve this problem, I ran series of test on my bulbs and finally discovered this, how do we resolve this?