A Sta-Rite Pool Filter’S Starting Procedure?

After the rinsing cycle, return the Sta-Rite Pool Filter to its filter position and turn off the pump. Reset the valve to its original filter setting and turn on the pump to start filtering water. Check the pressure gauge to ensure it’s back to its starting pressure. The STA-RITE System 3 is designed for swimming pools and spas and should be read by the end user to avoid unnecessary service calls and injuries.

To properly clean a STA-RITE System 3 Cartridge filter, follow these steps:

1. Turn off the system and release the pressure before starting.
2. Open the air release valve and release all pressure from the system.
3. Tighten the pump trap lid when using a Sta-Rite pump and trap.
4. Turn the locking knob counterclockwise to take the pool filter head off to access the pool filter cartridge.
5. Lift the pool filter head off so that the “start/stop” button is in “stop” or off mode.

In summary, the Sta-Rite modular media filter system is designed to filter water for swimming pools and spas. To replace the filter, follow these steps:

1. Turn off the pump and release the pressure before starting.
2. Open the air release valve and release all pressure from the system.
3. Tighten the pump trap lid when using a Sta-Rite pump and trap.
4. Remove the pool filter head from the pool and lift it off.
5. Check the “start/stop” button on the pump panel near the Sta-Rite logo in the bottom left hand corner to ensure it’s in “stop” or off mode.