The STA-Rite MAX-E-GLAS II P4E6D-150L water pump is a centrifugal pump with an internal trap. To remove the trap cover, follow these steps: stop the pump, close gate valves in suction and discharge pipes, release pressure from the pump and piping, check all clamps, bolts, lids, and system accessories before testing, and tighten Sta-Rite trap lids to 30 ft. lbs. (4.1 kg-m) torque for testing. If leaks occur, remove the pipe, clean off old tape, rewrap with one to two additional layers of tape, and remake the connection.
The pump should only be serviced by a professional. To repair the pump, use the Sta-Rite Max-E-Glas II and Dura-Glas II Pool Pump Parts. The tools required include a flathead screwdriver, 90 degree screwdriver, and 1/4″ and 3/8″ nut drivers. The pump should be serviced by a professional.
To remove trap covers that have been overtightened or taken a set and cannot be removed by hand, use the Sta-Rite U79-11 Lid Wrench. Lugs are provided, and if stuck, insert a screwdriver in the seam and gently tap it rearward. Insert a pump clear trap lid, which fits Max-E-Glas II, Dura-Glas II, Dyna-Glas, Dyna-Max, Dyna-Pro, and Dyna-Wave Pumps. The Trap Lid Diameter is 7-1/4″.
In summary, the Sta-Rite U79-11 Lid Wrench is designed for easy lid removal and is compatible with various pumps.
📹 Removing an old Sta Rite Max-E-Glas 2 Pool pump motor and installing a new pump motor
When the old pump motor started making a high pitched sound it was time to replace it. The motor ran for several hours everyday …
📹 Sta-Rite Motor and Pump Seal Replacement: How to change a Motor and Pump Seal on Dura-Glas Pool Pump
Sta-Rite Dura-Glas and Max-E-Glas Pool Pump Motor Replacement and pump seal installation. Century motor replacement wiring …
Add comment