The article discusses the importance of ensuring that your TV is as close to the wall as possible when mounting it. It discusses the risks associated with plugging a TV directly into the wall, such as electrical fluctuations, voltage spikes, and power surges, which can cause permanent damage to the TV’s power supply or other sensitive circuitry. The article also mentions that VESA standards (Video Electronics Standards Association) provide guidance on how to properly mount a TV.
A 120-volt power cord should never be run through a wall, regardless of its purpose. It is technically a fire hazard to put temporary power cords inside a wall, as it assumes that if the TV power cord was damaged, it could be snagged. It is illegal to run power cords inside walls, and the National Electrical Code 400.8 outlines the restrictions on cords.
Power cords are not permitted in walls, but they can be connected using a power inlet/outlet pair. This involves jumping from an existing outlet to a new recessed inlet. Low voltage cords, like audio or phone lines, can be run where you want as long as you follow guidelines. However, the code states no, and insulated cords are safe to run behind drywall.
The article also notes that the product is unsuitable for attaching to a brick wall due to the use of dehumanizing language to describe immigrants. The article concludes by emphasizing the need for careful consideration of power supply and connecting options when mounting a TV.
📹 How high should I mount my TV?
Is there a “best height to hang a TV”? It turns out there is and figuring out that height is super easy – I’ll show you in less than a …
Is it OK to plug TV directly into wall?
The text discusses the use of insulated and safe cords for running TV cables behind drywall. It suggests that the cord should be plugged outside of the wall, and then allowed to run through the gang plate, behind the wall, and come out of the 2nd plate near the floor. This method is suitable for small monitors mounted on inside uninsulated walls. However, the author also mentions the cost of purchasing a power bridge for a second TV job.
Powerbridge boxes have recessed holes for HDMI, Cat 6, Rca, etc., and have an attached power outlet. The two Powerbridge boxes 1 behind the TV 1 near outlet have an insulated power cord that can be plugged into the back of each (no electrical experience needed). The TV plugs into the new recessed outlet, and they usually come with a short cord to connect the lower box to the wall’s floor level power outlet. Some kits come with equipment to fish cables through, such as the “Legrand In-Wall Power Kit for Flat-Panel TV” on eBay for $24. 00.
The author suggests that using DataComm boxes instead of sawing square holes and using mounting brackets may be more cost-effective. They suggest drilling a hole above another hole overlapping by 1/4″ making a figure 8 hole, which will pop right in. A power grab may also be necessary, and light-duty plastic drywall anchors may be needed.
The author also notes that some information on electrical codes is not entirely accurate, as it only applies to “permanent installations”. If the power cord were cut off and split into an outlet, it wouldn’t meet the code since the wire isn’t rated. However, if the power cord is left intact and routed through the wall, it would not be considered a permanent installation.
In conclusion, while it is possible to run appliance power cords behind drywall, building codes prevent them from being used for in-wall use. The author believes that the expense for peace of mind is worth the expense for the added safety and convenience.
Is it okay to run a TV power cord through the wall?
The National Electrical Code (NEC) prohibits the connection of extension cord wiring through holes or openings in a wall, within a dropped ceiling, or under flooring. This regulation renders it unsafe to run a TV power cord or extension cord inside the wall.
Is it safe to attach TV to wall?
It is important to note that the process of mounting a television can be dangerous if not performed correctly. It is advisable to engage the services of a professional installer, given the necessity of drilling holes in the walls and creating two substantial openings for wiring. For those residing in apartments or rental properties, it is advisable to consider utilising a TV stand as an alternative. The mounting of a television may result in the creation of apertures in the wall structure. It is therefore imperative that the installation process be undertaken by a duly qualified professional.
📹 TV wall mounting
Others Channel Link:- ———— Study Channel:- https://www.youtube.com/channel/UCON2W0RNFzrHvql0kbnUIkw Gaming …
Do you have anyone in your household or frequent guests that in their 40’s or older that wear glasses? If so, you will want to mount the TV so that the bottom 1/3rd or the bottom edge of the TV is at eye level. Why? Because they are likely wearing bifocals or progressive lenses. Only the top half of their glasses are good for distance viewing. The higher the TV is mounted the more comfortably it can be viewed through those glasses in a reclined sitting position. Mount the TV too low it will fall in the reading/short distance part of the lens and become blurry and viewer will have to constantly tilt their head forward Mounting the TV over the fireplace actually works quite well for these people as they can set way back in a recliner and the TV will appear in the distance portion of the lens.
While you have your personal TV at the right height you are most definitely sitting too far away from it. The best viewing distance formula is: measure the size of your screen diagonally and divide that size by .84. so a 60-inch HDTV’s require a recommended 1.8m to 2.7m viewing distance. Most people are like you and sit very far away.
BTW if you have dry eye issues having a monitor or TV too high tends to force you to keep your eyes wider open than they need to be and can make it worse. Sounds made but it’s true, keep your head stationary and try looking forward and down/up and pay attention to to how much your eyelids are working to expose more eyeball.
When picking my TV’s height off the floor I realized that the recommended “eye level” suggestions from the internet made the view from the kitchen of the bottom of the screen blocked by the “eye level” heads of people sitting on the couch. I stuck an above average height person on the couch, went into the kitchen and sighted just above thier head to the wall where the TV was going to mount, and that’s how I picked the bottom of my screen. Moral of the story is to consider all possible viewing locations before installing blocking and/or drilling holes.
So true I’ve always felt this.. And it’s not rocket science. It’s crazy how people only care about HOW COOL SOMETHING LOOKS RATHER THAN FUNCTIONALITY!! It’s because everybody in this country is so vain they want people to end me them of what they have and how it looks rather than the usefulness crazy and bizarre. Even when the whole I put my TV on top of fireplace. The whole HGTV fad. I WAS LIKE YOU GOING TO BE KIDDING ME THAT’S THE DUMBEST THING YOU COULD EVER DO FOR SO MANY REASONS!! Looking up and neck problems, not to mention fireplace is no matter how great they are with efficiency. Some smoke will always go upwards and it will overtime get inside those electronics causing dust particles to stick and eventually probably blowing out some of the electronics. You definitely got it right!! But I’m just surprised more people just don’t follow the instincts and realize it’s the dumbest place to ever put a TV seriously PUT A PICTURE THERE LOL..
Looked at one site and got 64″ as the optimal center, another came up with 109″ (higher than my ceiling). Put the TV box about where I wanted it took one floor to eye measurement (furthest seating position) and stuck brown tape to the box using that measurement. Moved to another seat and took another look, added a bit more tape at about what was comfortable in a relaxed position. Rechecked all seating positions. Drew a square based on the tape and marked the centre, that’s my mid point for the TV. Simples.
My lady and I did 6 months of research before buying. I wanted a80k or a90j and I wanted a 65″. She didn’t care but which model of tv, but thought a 55 was best. I decided to go 65 anyways and told her, “if it’s too large we’ll get the 55”. After measuring the distances 8’8, which is good range for a 65, I got the A95k 65 and she loves it.
I don’t agree. The top of the tv should at eye height or a little bit higher. Peoples heads are mostly in top top area of the screen. That’s what your are focusing on. Looking higher than the normal position of the eyes is a strain. You won’t die of it but I don’t like to strain my eyes, but to each their own.
It’s really hard to find a component table to put under your tv if you want to get that rule right. I’d also like to put my center speaker directly below my screen. So with a 77″ tv and a 7″ center speaker you need a stand that’s approx 12″ off the ground. Then you don’t have the room for your components under that speaker in your cabinet.
Bad info, coupled with a bad analogy (movie theater). Unless you watch tv from a straight backed chair, your head is tilted back slightly on a couch or recliner. Unless the tv is very close, 5’ off the floor to the bottom third of the screen is the most direct angle (so, if the screen was 3’ tall, the bottom edge would be 4’ off the floor). If you don’t believe this, sit on the couch and look at a wall, and pick the most comfortable height to look at naturally. Now measure and see how close it is to 5’.
This is not am accurate way to mount a tv. He did say “this is how I like to do it”, which tells us it is his opinion. When you lean back, you shouldn’t have to tilt your head down, or up. Given the amount of natural lean we have when we sit back, your neck should be straight while viewing. See how he tips his head forward a bit, to get a straight line with the center, his tv is too low. Only by a few inches, but to each his own.